Videovox Pro LNS series Manual de usuario descargar pdf (Pagina 47)

Current device：dome

RS485 address：1

ID: 0

8 Network Keyboard Operation (based on DH-SD)

Note: all the operations here are based on DH-SD protocol. You can refer to

Chapter eight for PELCO protocol operation.

8.1 Dome and Network Keyboard Connection

Connect dome A cable with Pin 3 or Pin 7 of Keyboard 485 interface. Connect

dome B cable with Pin 8 or Pin 9 of Keyboard 485 Port.

8.2 Network Keyboard Setup before Operation

Before setup please make sure:

• Keyboard and dome cable connections are right.

• Connect dome with power source and connect dome video port with monitor.

• Set PTZ decoder address. (Set 485 address as 1 if decoder address is 1.)

• You have set control point.

When you click ESC, system pops up a warning

dialogue.

Click ENTER to save setup or click ESC to exit.

Note: all the items listed here should be properly set. ID, device name, serial port

and IP are all unique.

ID：*0

Device name： ①

Device type：Dome

Connection：RS485

485 address：1

parity：None

Protocol：DH-SD

Stop bits：1

Baud rate：9600

Data bits：8

Here is for you to set ID, device

name and device type. Click ID to go

to current device connection

interface.

Move cursor to highlight “connection”

and then click ENTER. System goes to

RS485 setup. RS485 address is 1.

Default protocol is DH-SD. After all the

setup, please click ENTER to save

modification.

Save Data？

Yes: ENTER, No：ESC

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 60 61

Sin comentarios

Videovox Pro LNS series Manual de usuario Pagina 47