Videovox Pro LNS series Manual de usuario descargar pdf (Pagina 40)

3.54.5 Motion Detect

4.5.1 Go to Motion Detect Menu

In the main menu, from Setting to Detect, you can see motion detect interface.

See

394HFigure 4-14.

4.5.2 Motion Detect

Detection menu is shown as below. See

395HFigure 4-14.

z Channel: select the channel you want to implement motion detection.

z Type: in the dropdown list, select motion detection item.

z Record channel: select the channel to activate recording function once alarm

occurred. Please make sure you have set MD record in encode interface(Main

Menu->Setting->Schedule) and schedule record in manual record interface(Main

Menu->Advanced->Manual Record)

z Enable tour: Here is for you to activate tour between different cameras.

z Latch: when motion detection complete, system auto delays detecting for a

specified time. The value ranges from 10-300(Unit: second)

z PTZ preset: Click set button, the interface is shown as in

396HFigure 4-15.Here you

can set preset for one or more channels.

z Region: click “select” button to set motion detection region. See

397HFigure 4-16.

z Sensitivity: there are six levels. The six-level is of the highest sensitivity.

z Alarm output: when alarm occurred, system enables peripheral alarm devices.

z Show message: System pops up message in the screen to alert you once alarm

occurred.

Please highlight icon to select the corresponding function.

After all the setups

please click save button, system goes back to the previous menu.

Note:

In motion detection mode, you can not use copy/paste to set channel setup since the

video in each channel may not be the same.

398HFigure 4-15, you can left click mouse and then drag it to set a region for motion

detection. Click Fn to switch between deployment and withdraw motion detection.

After setting, click enter button to exit.

Figure 4-14

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 106 107

Sin comentarios

Videovox Pro LNS series Manual de usuario Pagina 40